This IR remote control that you can use to control other devices or circuits up to 8 devices. The control codes are sent in RC5 format modulated to about 38 kHz carrier frequency.The IR transmitter powered by the CR2016 which is a 3V button Cells Battery CR2016.To extend the life of the battery this is done by putting the CPU into SLEEP mode for most of the time and wake-up only when a key is pressed. PIC16F630 is the heart of the transmitter used to send IR command to receiver.It also generate 38KHz carrier frequency.The CR2016 is 3V battery which is supply for the circuit. When any key not pressed the CPU work in SLEEP mode to reduce baterry power consumption and wake-up only when any key pressed. To wake-up the CPU from SLEEP mode the CPU use interrupt on change feature which interrupted when the state on PORTA change then the program execution after an interrupt is at the interrupt vector, if the global interrupt is not enabled, the program starts executing the first line of code right after the SLEEP instruction.In the interrupt service routine the software will scan the key that pressed and send IR command appropriate with key pressed.

     2-CH RF Remote Control
     Infra Red Vision System for a Toy Cars
     2 Channel RF AVR Remote Control
     433MHz RF Modules
     2-Channel IR Relay Controller
     Simple IR Remote Receiver with Decoder
     8 Channel RF Remote Control
     2 Channel RF AVR Remote Control
     Simple 4-CH Remote Control
     RF Remote Control Light Switch

Circuit-Zone.com © 2007-2024. All Rights Reserved.